![]() You might also need to set the S-Value Max setting in LightBurn. ![]() LightBurn Software Forum – 4 Mar 19 How to NOT print toolpath between objectsĬhances are that you’re using an older version of GRBL on your machine, meaning you’d need to use the GRBL-M3 device in LightBurn. I started to look for a solution for the toolpaths and I found the following post: Two interesting things are occurring: 1) the toolpaths between objects within the same layer are burned in the wood and 2) the edges of the engraved circles are deeper with respect to the inside. LightBurn (Oz) October 25, 2019, 3:48pm 7 Grayscale with diode lasers is much easier than with CO2. To test the engraving capabilities of the machine, I used an engraving template, which I adjusted to realistic speed and power settings (speed 20 to 100 mm/s and power 0.2 to 1%), see the picture I added to this post. After cleaning and replacing some parts, the laser path and laser tube seem to be in good order. ![]() Overscanning When enabled, adds extra moves to the beginning and end of each line to give the laser time to speed up before firing, and slow down afterward. I am a new user of a (2nd handed) MK4 machine and I am trying to get it up and running to its full potential. This is useful for engraving slate or glass, where burned areas become lighter.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |